Cisco Home Community

[Rockem]

I too cannot get the wireless side to connect to the internet. I've tried everything including sending it back to inksys for repair. I do not know what they've done. But it seems like they just sent it back without even looking at it. I have yet to use this  product.

(Mod Note: Edited due to non-compliance of forum guidelines.)

Message Edited by daikunzeon on 09-01-2007 12:02 PM

[demonhunter05]

hey, can anyone help with getting into this router i type the ip address 192.168.1.1 and i have the internet cable plugged into the internet port and a cable plugged into the #3 port going to my computer. nothing i do will let me into the router, i have reset the thing like 20 times. and i still can't get in. and the one time it let me in, it timed out. my ip address settings are set to automatic. any help would be greatly appreciated. is there a different ip addess to try or something? thanks

p.s. i have even tried pinging it 192.168.1.1 and that gives me a failure as well.

[Dudeadillo]

For those who have had wireless only issues w/ this router, I found a solution that worked for me.  Hopefully, it will help somebody else.  It's the "Network Density" setting under the "Wireless"->"Advanced Wireless" tab.  The default setting is "low" so I moved it to "medium" and all of sudden, everthing seemed to work better.  My packet loss/speed went from 25% loss/200ms to 2% loss/4ms. This setting apparently increases the transmitting power of the wireless signal.  After somehow noticing that the number of Wireless SSIDs I see in my area grew by 3x-4x in the last few months, I decided to give this a try.

Again, I hope it helps somebody.  I have never had the wired connection drop that some of you mention.

[saberman]

>My packet loss/speed went from

Is that from the router side or the laptop?  I can't find any type of network metrics in the router screens.

[faith1936]

I have been unable to open a download for my Linksys.  Without taking another look for it.  It is download 1.00.20  My current version is 1.00, I think.

Can someone suggest what the problem is and how to fix it?

Thanks for any help.